The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re looking forward to the workout you’ll get from using it. Perhaps you’re a little relieved to have actually finally made a selection from the various models you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that gets back with your new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as soon as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely small as they rise from the water surface area. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made of specific areas, at varying speeds. So eventually you’ll observe a couple of of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help due to the fact that you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a various style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately wind up in some landfill, they developed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this website so you can discover it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *